Bed slat

1. Radius of curvature: 5000mm 2. Tolerances: +-1 mm in lenght and +- 0,5 mm in the width and +-0,5 mm (only in plus) in the t

1. Radius of curvature: 5000mm 2. Tolerances: +-1 mm in lenght and +- 0,5 mm in the width and +-0,5 mm (only in plus) in the thickness 3. Class of formaldehyde emission: E1 4. Finish: resin finish to under side,upper side to have beech printed foil. 5. The surfaces must be smooth (any glue remainings to be removed) 6. The edges rounded: rounded enough to put slats into plastic holders (the edges cannot be sharp (square-cornered) 7. Any core gaps holes on the edges are not allowed; if they appear, the must be glue-filled but the surface must be cleaned after suchaction. Fillings should not be visible and stick out. After filling holes with glue it must be polished.8. Face foil must be in one piece, without any joints. 9. Some small, not falling out knots ( point-knots) and some discolorations are allowed on the bottom side10. The manufacturer should paid attention to the production to not use too hot material - after such quick production the effect of"propeller blade" appears (slats are warped, a little bit "twisted")11. Packing: slats can be pak in bundles . Ready pallets should be well protected before binding it with metal band. Best way is to putthin layers of plywood or chipboard or particle board before bindingwith band. It can be wrapped also in thick foil before binding (orboth board and foil).

Bed slat